Product Name: Active Probe
Display Screen: LCD
Number of Tests:
1.DC Volts Measurement
2.ECU wire Test with simulated output voltages.
3.Dynamic DC Output for electrical component tests e.g. Radiator Fan, Wiper motors, Power windows, Sensors, etc.
4.Relay Function Test.
is designed to provide additional help to automotive technicians in troubleshooting
electrical circuit problems in the car. Once you connect the Active Probe to your car
battery, you will have access to an amazing variety of diagnostic functions.
Use the probe tip and ground lead simultaneously to power up components right
in your hand, conduct voltage measurement on a running circuit, simulate sensor
voltage output and some other functions.
using the normal multi tester, this probe can be used to provide additional
functions to assist in diagnosing electrical or components faults or failures
in the vehicle.
function of this Dynamic Active Probe has divided into four as follows:
measure the voltage present in the wire and display the actual battery volts (from
Battery) and the tip voltage (Measured voltage). This determines whether are there
any resistances in the wire that contribute to the difference in the voltages.
2. ECU wire
This test simulates sensor
output voltagein order to verify
the wiring going to the ECM/ECU.
The output voltage can be adjusted from 0.5V
to 5.0V with increments /decrements of 0.5V at fixed constant amperage output
of 20 milliamps max. This is very useful for simulation of a variety of sensors
voltages to fool the ECM/ECU when troubleshooting of sensing problems with an
3. Dynamic DC
Output for electrical component tests
Selecting this mode will provide DC voltage output
into two preferences.
3a.Full battery voltage output
Provides provide voltage
output to power any electrical components using whatever available voltage in
the battery up to maximum 10 Amps output for testing dynamically. Depending on
the connections required, it will show positive voltage output or negative (-)
output during power out activation.
3b.Adjustable voltage output
Allows DC power
output to be adjustable from 1.0V to 12.0V with increments or decrements of
1.0V each press with a constant amperage output of 5.0 Amps maximum. This
feature will allow dynamic testing of a variety of electrical components that
operate within these power limits.
The display of both setting will show actual Volts, Amps draw and
Resistance in the circuit during power activation run.
There are 3 modes of power
output activation as follows:
During power out
activation, the tester will show positive voltages output or negative (-)
output depends on the connections. At the same time it displays the amperage
drawn and the calculated resistance produced by the electrical component under
test as shown.
Tester (Test continuity and activate simultaneously)
test will be controlled under [Dynamic
DC output for electrical component test] whereby the voltage can be
adjusted to control from 1V to 12V output. This is very useful for testing a
wide range of Relays ranging from 1V to 12V input where 6.0V (motor bikes) and
12.0V (cars) relays are the most common ones.